First, the installation: non-live action! 
 1, cut off the power, the remote control wall switch as shown in the figure, the line of fire and light line access switch cassettes within the terminal, and tighten the screws. 
 2, press the first button on the left to start the access OUT1 lamp, and then press the key, close the lights. 
 3, followed by pressing the second and third key mode of operation above.  

 Second, the learning remote control: Please follow the instructions step by step operation. 
 1, first click the first button remote control switch, the lamps light up the road, and then press and hold the button (light off) for about three seconds or so until the light off to light after the release the button, lights still remain bright state, then 5 seconds to press the remote control of your choice and key number, lamp if off, that success in learning. Operational procedures: press control button to start light ... let go ... ... and then press and hold 3 seconds from the off to the bright lights ... ... ... press the release button remote control lights are out ... ... success. 
 2, remote control wall switch in the computer chip programming for each button can also learn 4 different remote control button codes. 
 3, second and third key to the learning process as above. 
 4, when set up, you can conduct remote control. 
 5, removal has been a good learning (password) remote control. Press any key on the panel, in the state to maintain the status lights Bu Songshou, about 8 seconds, the light goes out into the light, you can clear all learn a good remote control, removed, remote control of the remote control can not switch, need to learn again only after the above remote control. Note: The switch in the first use, it is best to clear the factory left in the test product during the encoding. 
 6, with a fully open, fully closed feature: For the studied 12 key remote control button to automatically default to 11 - "open", 12 key - "all closed." 

 Third, technical indicators: 
 1, Rated voltage :100-250VAC; 50 \ 60HZ. 
 2, rated load: resistive: 600W; sensibility: 200W; 
 3, Control distance: more than 50 meters high power remote control, low-power remote control is not more than 20 meters. 
 4, the receiver sensitivity:-95db. 
 5, receiving frequency: 315MHz. 
 6, standby current: 50uA. 
 7, standby power consumption: 0.016W. 
 8, for a variety of lamps and starter-type fluorescent lamp has a small part of the use of counterfeit brands of starter Philip Please note that if does not work, replace the starter to the other. 

 Fourth, the product description: 
 1, Model :98-8601A (Single) ,98-8602A (2 Way) ,98-8603A (3 Road); 
 2, Size: 86 GB, direct installation. Replace the original wall switch or straightforward. 
 3, housing: PC fire-retardant plastic, polished surface, eyebrow metallic luster chrome frame, large toggle touch of a button. 

 Non-live action! Non-professionals to operate strictly prohibited!